Can I fit a 1.6 fuel tank to a 2.0?

Please restrict your questions and replies to Capri related technical issues!
Post Reply
Andyb1981
Posts: 18
Joined: Wed Dec 31, 2014 8:05 am
Car(s): Ford Capri 2.0 Laser, rolling restoration project.

Skoda octavia 1.6 diesel (work car)

Can I fit a 1.6 fuel tank to a 2.0?

Post by Andyb1981 »

Hi, my fuel tank on my 2.0 laser has had it. I'm struggling to find a replacement. I have the chance of a better (if only slightly) 1.6 tank but it seems to have one less breather pipe than my current tank.
I was wondering if I could swap the tanks over with no problems?
I should also mention my capri has, at some point, had a 1.6 sender unit fitted as it does not have a return pipe fitted.
Believe it or not I only set out to change the rear spring bushes.

Thanks Andrew
User avatar
Peter-S
Donator
Donator
Posts: 7455
Joined: Mon Jul 28, 2008 7:57 am
Car(s): 1985 Capri 2.0
1983 Capri 2.8i
Location: Kent
Contact:

Re: Can I fit a 1.6 fuel tank to a 2.0?

Post by Peter-S »

The 1.6 and 2.0 tanks themselves are identical so you can just swap the sender over and all should be well although I'm a little puzzled by your comment on the breather pipe - is there definitely something different?
ImageBanner by Peter Smith, on Flickr
Andyb1981
Posts: 18
Joined: Wed Dec 31, 2014 8:05 am
Car(s): Ford Capri 2.0 Laser, rolling restoration project.

Skoda octavia 1.6 diesel (work car)

Re: Can I fit a 1.6 fuel tank to a 2.0?

Post by Andyb1981 »

Hi Peter, there is definitely something missing. It's the breather pipe (I'm assuming it's a breather) that runs from the top offside of the tank. It's only about 7 or 8" long and just clips to the lip of the tank. I'm just wondering if the tank is off an early mk3.

Cheers
User avatar
capri dave
Posts: 649
Joined: Wed Aug 20, 2008 6:30 pm
Car(s): 86 Capri 2.1.

00 Escort 1.6 finesse
Location: Coventry

Re: Can I fit a 1.6 fuel tank to a 2.0?

Post by capri dave »

is the extra hose a fuel return pipe ?
simon
Posts: 152
Joined: Wed Apr 18, 2012 5:51 pm
Car(s): ford capri

Re: Can I fit a 1.6 fuel tank to a 2.0?

Post by simon »

hi, there should be 2 thin metal pipes coming out the top of the tank one in each corner where a piece of rubber pipe connects from one end to the other end , as i remember i think its around 6mm wide . This is to let the air circulate around the top of the tank. make sure you have this pipe connected on both ends. Then you should have a breather fitted in a hole in the top of tank and a piece of pipe fits on this around foot long comes around level with bottom of tank when fitted and clipped on side of tank. it is very important to make sure this pipe clips on to the side of the tank when connected on the breather .the reason its fitted and clipped on the side of the tank is that if you have a accident and role your car upside down is that the petrol in your fuel tank will not spill out on the floor as this pipe stops it leaking all underneath your car stopping a fire . if you think about it and the cars upside down the fuel will just leak out with no pipe on off the breather , so when the pipes facing upwards the fuel cant escape out your tank all over the road hope this helps .
Post Reply