The Ford Capri Laser Page

i see its coming along nicely loveing how clean the cossie lump looks. i sore a mk1 capri rs3100 replica at a car show once which had the super charged version of this engine in it looked and sounded awesome and i bet it flew as well

cheers mate,

ive got the legs back on just need to bleed the brakes next week

the car had sat stationary since i replaced the front brakes as the master cylinder couldn't cope with the new brakes,

fitted a land rover master cylinder last weekend, there brillaint now



also replace the fuel lines as they were in a poor condition



car is running well too.

Take one crashed 24v cosworth capri and whack it all into your capri.

So far just got the 2.8 rack and front coil overs off the red one in mine, still need to do rear LSD with disc brake cables etc and fuel tank and lines, the engine and box then I've got to wire it.



Paul.

Fuel tank and lines in



LSD axle on and exhausts



Back on all 4 needs some lowering action though



Paul.

Engine and box, slid straight in.

See you again

Where's she off too ?

coyb1878 wrote:Where's she off too ?

I've just driven it to just south if Aberdeen, it's going for restoration over on Orkney,

Done 874 miles today birmingham to nearly Aberdeen and back

Paul.Yeomans wrote:

coyb1878 wrote:Where's she off too ?

I've just driven it to just south if Aberdeen, it's going for restoration over on Orkney,

Done 874 miles today birmingham to nearly Aberdeen and back

Since no one else has asked, why Orkney?

Peter-S wrote:

Paul.Yeomans wrote:

coyb1878 wrote:Where's she off too ?

I've just driven it to just south if Aberdeen, it's going for restoration over on Orkney,

Done 874 miles today birmingham to nearly Aberdeen and back

Since no one else has asked, why Orkney?

I'm sending it too

http://www.quoyloogarage.co.uk

Seen his work on the capripower site and the welding and engine conversion work looks spot on,

Had a look local but thought I'd send it there in the end

Turbo tail



DIY clear lenses



Cars currently at Steadspeed restorations getting sorted out. Hopefully have it back first few months of next year.
Paul

This project is still going, the cars still on Orkney



Wiring loom been chopped about, hopefully have a running engine this week



Paul.

Been a long time coming! Fair play for sticking at it though and thanks for updating -look forward to seeing it come along, will look great when finished