Please restrict your questions and replies to Capri related technical issues!
5 posts • Page 1 of 1
- Andrew 2.8i
- Posts: 12013
- Joined: Sat Jan 25, 2014 7:38 pm
- Car(s): '83 2.8 Injection (sunny days only)
'04 Toyota MR2 (owned from new)
- Location: Ceredigion
- Posts: 1271
- Joined: Fri Jul 03, 2015 5:21 pm
- Car(s): MK 3 3.0S needing restoration, 2.0S, 1.6 Laser (nearly ready), Fiesta mK2 pop plus, Skoda Octavia VRS, Rover SD1 Vitesse.
- Location: High Wycombe
Mattcapri wrote:how comes inners seem to be so much more expensive and harder to find than the outers?
I think the reasons would be that there is less demand for inner sills and Expressed panels are the only company that make them. Further, Expressed panels are hand made to a high quality and would fit straight on to a prepared car without a lot of fettling being needed - they are made to Ford specification.
With Capri's I think many people just repair their existing inner sills if it's just and inch or two of grot at the bottom - depends whether you are doing a concourse resto or not.
yep mine arnt too disasterous, but im putting new floors in and to be honest i may as well just go the whole hog and replace the inner sills too- at least it will look as it should and finish the job off nicely.