Headlight wiring block disassemble
Posted: Sat Oct 06, 2018 6:58 pm
After a bit of advice, I'm replacing my original headlights with some H4 units.
I've tracked down what wire does what with regards to sidelights, main etc. Ideally I want to get the pins out of the connecting block that secures onto the back of the lights, so I can swap around the wires and isolate the sidelights to the separate pilot light in my new units.
Can anyone explain a technique to get the pins out of the block successfully. I mean I could just cut the wires and re-spade, but that feels like a bit of a hack.
Cheers
Stu
I've tracked down what wire does what with regards to sidelights, main etc. Ideally I want to get the pins out of the connecting block that secures onto the back of the lights, so I can swap around the wires and isolate the sidelights to the separate pilot light in my new units.
Can anyone explain a technique to get the pins out of the block successfully. I mean I could just cut the wires and re-spade, but that feels like a bit of a hack.
Cheers
Stu