Ballast Resistor
-
- Posts: 2
- Joined: Mon Jul 16, 2018 9:22 pm
- Car(s): capri 2.8 tt
Ballast Resistor
Have i got a Ballast Resistor on a 1969 Capri 1600 GT. If so, where is it hidden.I have electronic ignition fitted, but on tickover after 5 mins car will start to misfire and cut out. If i put direct 12 volts from battery car ticks over fine
-
- Donator
- Posts: 1893
- Joined: Tue Jul 29, 2008 5:23 pm
- Car(s): Diamond White Granada 24v
Caspian Blue Sierra XR4i
Stealth Grey Focus RS
Storm Grey Fiesta ST200 (actually belongs to the missus!)
Mean Green Fiesta ST-3
Re: Ballast Resistor
If you can’t see it then possibly not as some electronic ignition systems don’t require one at all if I remember correctly. Also, (if my memory serves me correctly - it’s years since I played with Capris!) some electronic setups require a higher capacity coil so it may be worth looking at that too.
-
- Posts: 195
- Joined: Sun May 11, 2014 6:43 am
- Car(s): I have got a 1981 3000s and I have just got my self
A 1987 2.8i thay are both red
I had my first capri when I was 17" it was a 3000GTXLR
I have had a lot of fast fords vans all ways put bigger engine in
I also have had motor bikes I have a 1200 Suzuki bandit - Contact:
Re: Ballast Resistor
there is a wire in the lome that as a ballist it’s a light blue
-
- Donator
- Posts: 1893
- Joined: Tue Jul 29, 2008 5:23 pm
- Car(s): Diamond White Granada 24v
Caspian Blue Sierra XR4i
Stealth Grey Focus RS
Storm Grey Fiesta ST200 (actually belongs to the missus!)
Mean Green Fiesta ST-3
Re: Ballast Resistor
So bypass the ballast wire and use a 12v coil may be the easiest solution(?)Bod9084 wrote:there is a wire in the lome that as a ballist it’s a light blue
- nigecapri
- Posts: 5795
- Joined: Mon Jul 28, 2008 6:31 am
- Car(s): Black 2.0S with supercharged bike carbs.
- Location: http://www.blacklabradorpuppies.co.uk/
- Contact:
Re: Ballast Resistor
On later models the ballast resistor is built into the loom where it runs across the bulkhead. Thicker than the other wires.
-
- Posts: 2
- Joined: Mon Jul 16, 2018 9:22 pm
- Car(s): capri 2.8 tt
Re: Ballast Resistor
Was going to cut ballast out of loom to keep bay original.