O/S rear quarter - the door striker plate is secured via 4 screws to a plate with 4 threaded holes sitting behind the B pillar - this plate sits in a 'cage' behind the B pillar to stop it falling to the bottom of the rear quarter if ever the 4 screws are undone. Question - can this plate be removed from the cage somehow? I wish to get a paintless dent removal bar in via one of the 4 holes in the B pillar but can't with the plate in its 'cage'. Haven't quite got enough access to see if the plate comes out - hence my question
Thanks
Door Striker Plate
-
- Posts: 2149
- Joined: Tue Jul 29, 2008 6:40 pm
- Car(s): 1984 B Reg 2.8i rebored to 2922cc near concours condition. Restored from near scrap condition.
1983 A Reg 2.8i Caspian Blue over Silver. Ongoing now roadworthy project from scrap condition - Location: England
Re: Door Striker Plate
The “cage” you refer to is spot welded on all sides so the threaded plate can’t come out.
-
- Posts: 35
- Joined: Tue Mar 21, 2017 6:49 pm
- Car(s): FPV Pursuit ute, Capri 280, Audi A4 cabrio, rusty Transit
Re: Door Striker Plate
Thanks for the reply - got my phone in there and as you say the 'plate' is trapped
Got an annoying pin prick of a dent - easily massaged out with a PDR tool
gifs upload
Got an annoying pin prick of a dent - easily massaged out with a PDR tool
gifs upload