Anti Roll Bar Nut Seized
Re: Anti Roll Bar Nut Seized
I have quite a few sets of rubber leaf spring bushes that I have pressed out of brand new leaf springs in order to fit polybushes.
- pbar
- Posts: 7533
- Joined: Thu Jun 07, 2012 6:29 pm
- Car(s): Capri 2.0 Laser, frequent driver.
- Location: North-West
Re: Anti Roll Bar Nut Seized
Well I got the nut off, used a nut splitter. I bought a pack of two of these (which covers an assortment of nut sizes) for a previous job but didn't need them at the time. Came in very handy now though. Excellent little tool.
- pbar
- Posts: 7533
- Joined: Thu Jun 07, 2012 6:29 pm
- Car(s): Capri 2.0 Laser, frequent driver.
- Location: North-West
Re: Anti Roll Bar Nut Seized
They arrived today, that was quick! And yes, I agree very good quality. Fit perfectly too. Thanks again.pbar wrote:Thanks Andrew, appreciate it, with that being the case, I just ordered that set. Thanks also to Neil again for posting the link.Andrew 2.8i wrote:Hi Paul,pbar wrote: Those will fit on any diameter ARB then I take it?
I think the Laser has got the 24mm anti- roll bar, the same as on the 2.8. I bought that very same item from the same seller and they are very good quality and fit fine. I found that the supplied dished washers are heavy duty and up to the job.