Kurust tip

You can RANT and RAVE to your hearts content here instead of clogging up the Q&A Technical Forum!
Report any offensive posts to [email protected]
Post Reply
tejb1
Posts: 193
Joined: Mon Jun 22, 2015 1:12 pm
Car(s): Capri 1.6L (weekend/holidays)

Kurust tip

Post by tejb1 » Wed Oct 03, 2018 5:58 pm

I've got this week mainly off, so have been dealing with a few bits of surface rust and stone chips before it gets too cold to do anything over winter. I've been grinding back to as clean metal as possible, then using Kurust before priming. The stuff is a right pain to get off brushes etc and runny as anything.

What I tried, and worked really well, is applying it with a sponge. I bought a cheap pack of dishwashing sponges and cut one to approx 1" width, tore off the scourer backing, dipped it in the pot and it applied beautifully. Much fewer dribbles and a more even application. P.S. wear gloves, it gets everywhere!

Anyway, just thought I'd post this here in case it helps someone else, it may be a well known trick or something but anyway!

Cheers
Tom.

User avatar
Andrew 2.8i
Donator
Donator
Posts: 12269
Joined: Sat Jan 25, 2014 7:38 pm
Car(s): '83 2.8 Injection (sunny days only)
'04 Toyota MR2 (owned from new)
Location: Ceredigion
Contact:

Re: Kurust tip

Post by Andrew 2.8i » Wed Oct 03, 2018 6:07 pm

tejb1 wrote: P.S. wear gloves, it gets everywhere!
And stains your fingers!

Great tip about the sponge Tom, thanks! :D

Andrew.
Image

Post Reply