ok but its not all plain sailing for me.
when i write the map ive made ot the mjl and then switch maps and write the same map to the second option (via the switch in the car) it doesnt seem to remember them.
i see this because i use the 'get config' button (next to write config) but when i use that button, a different map loads up (i assume from the mjl).
to get around this, i have the switch in one position, then ope up the map ive made and then write it to the mjl. then start the car and it works, timing changes as the rpm and load changes. but then if i swap to the other map it loads up, with a different map.
it doesnt appear to be saving the maps i write to it, even though it say it does.
any ideas?
"Understeer" is when you hit the fence with the front of the car.
"Oversteer" is when you hit the fence with the rear of the car.
"Horsepower" is how fast you hit the fence.
"Torque" is how far you take the fence with you.
