The Ford Capri Laser Page

Guys the valance is genuine ford, as far as I know there have never been a pattern replacement made

If any one is after one I have an NOS mk3 front valance, i never needed it for my restoration so is now spare, it's just been etch primer for protection

Andy

Guys after a genuine mk3 front indicator must have both fixing lugs in tack and uncracked if anyone has one they want to part with

Andy

Thanks Andrew, yes your right about your foot down, you need to wind these standard pintos up, get that second choke open , like being a teenager again, I will check the post in the gallery

cheers Andrew

Thanks Rob, looking back now it all seems worth it but at times during the rebuild I did ask myself what have I started, now all I want to do is drive the thing, as I have had the car so long it's like going back in time.

Guys, I have just been through a very intense rebuild to my 78 "S" which I have owned for nearly 30 years!, its been stuck in the garage for a long time up until this started back in September last year, but finally its 99% done and drivable and I can now put my feet up! the first photo is...

Thanks Steve, that is pretty much the same and it does show the seal I was questioning clearing pointing outwards, so that convinces me mine is in correct. The bore on mine looks fine but that rear seal is clearly worn as its lost its lip a bit and that would answer why the brake fluid has striped t...

Yep I took photos but I am questioning the back seal as that's where it was letting by, as you say stick it back as was

Andrew now we have found a picture, it's actually the one on row ten, it's the back seal, unless I am convincing myself it looks like it's wider end is inwards?

Andrew, I have that wiki page but it's to had to see, I believe it's the correct cylinder but it just to hard to see but thank anyway

Thanks Steve, that is a good picture but Sod's law mine is different, that picture shows 6 seals and mine only has 4, my piston is released by a pin in the reservoir entry

Guys does any one have a drawing of the way around the rubbers go on a girling master cylinder?, on the piston with the longer spring, the one that goes in the cylinder first both rubbers narrowest part face inwards but on the other piston the last rubber nearest the opening or end of the cylinder t...

Andrew thanks for your reply and yes I do mean the switched feed to the fog light switch is dead when the head lights are on or off, I assume from your comment that this feed is picked up from the headlight stork switch

Guys, can any one tell me if there is a relay for the rear fog lights, if so where is it? mine are not working and the switch is dead when dipped beam is on

Thanks

Guys, I am fitting a new tailgate to my 78 mk3 and I think the wiring points on the tailgate for the heated screen and wiper are diffrent on the pre bonded screen, so I was wondering if anyone would be kind enough to do me a template of the holes for the wiring ect for a pre bonded screen. I would h...

Hi guys I am after a couple of chrome coloured ghia wheels centres if any one has any

Thank Andy

Hi guys I am after a couple of chrome coloured ghia wheels centres if any one has any

Thank Andy